1994 Yamaha XV 535 Virago DX "remove stuck piston rings" Questions

...Remove all of the spark plugs. (2) Disconnect the fuel lines. (3) Pour light weight oil directly into the heads.(I know, sounds weird) (4) Crank Crank Crank Crank. Until the engine turns smoothly. If ...

...stuck in the piston and were hard to remove This is a Honda GC160 5 hp engine. I just finished putting in new rings and rod ( left piston alone even though it was scored on 2 sides) and put it back ...

...stuck in the bottom of the kick? If at the top; Remove the spark plug so you will not have to deal with the compression confusing the issue. First, with bike in neutral does the engine turn over ...

...stuck and it wont turn , not enough power. How can we fix that If the piston is seized up you will need to remove the cylinder head, the the cylinder, then the piston. Tank the cylinder and piston to ...

...stuck open allowing the fuel to pass thru freely and into the intake system in which it the goes to the crankcase as it passes down thru the piston rings. Remove, clean, and rebuild the carbs. You ...

...remove the push rod tubee on the front jug.see if the pushrods are moving up and down.see if they are loose.if loose adjust try again. your valves may be stuck open if not stuck open pour 1 once of ...

...stuck open. Turn off the gas and drain the carb. Next, turn the gas back on and sharply tap the float bowl with the plastic handle of a screwdriver as the fuel bowl refills. The goal here is to ...

...stuck in the piston, not allowing the rings to seal the bore, remove the exhaust and look up the Port the piston should look as new with no scoring to it, any damage will prevent the engine from ...

...stuck to disk?. If yes, try operate foot brake and see if piston moves to press pads and releases. If not, disassemble caliper from disk, remove brake pads, clean exposed area around pistons using ...

...Remove the seat, tank, pipe and maybe the carburetor and you should be able to get at the head bolts. Pull the head and inspect the top of the piston and ring area. Rings usually get stuck to the ...