Question about Yamaha FZ 750 FT (U.S Motorcycles
...years,when i got it started and reved engine sparks and fire came out of tail pipe One or more carb floats is probably stuck open. This causes unburned gas to get into the tailpipe. The sparks and ...
...stuck carb floats / non-seating float needles that aren't cutting off the flow of gas from the tank when the carb bowls are full. The excess gasoline should be spilling out of the carb overflow ...
when the engine is running. Is the float stuck? either the float is stuck in the down position or the float needle cannot close properly due to debris in the float valve or a worn float valve assembly
Question about Yamaha FZ 750 FT (U.S Motorcycles
...stuck float right? Yep you got it a stuck float or possibly a plugged main jet, but more likely the float....and probably its not stuck, its probably bad and needs replaced, if there is fuel in the ...
...float is stuck in the closed position. Remove the float bowl on the bottom of the carb and spray carb cleaner at th float needle. Gently lift the float upward then let it drop. Repeat this several ...
stuck (or bad) float. Remove the bottom bowl of the carburetor. Inspect the little plastic float and make sure it's not stuck in place. Make sure that the plug did not come out from the float bracket.
...float is stuck, grab a screwdriver and tap the carb float bowl with the handle. you should be able to see this from the bottom of the tank. hopefully this will unstick the float. if it doesn't, then ...
...stuck float, a stuck float needle, or a worn/bad float needle. Tap on the bowl of the carburetor with the plastic end of a screw driver. This may unstick the float then, a fuel system cleaner like ...
Question about Yamaha FZ 750 FT (U.S Motorcycles
...find an atv category. The float is stuck open. Remove the carb, remove the bowl then clean the carb with spray carb cleaner. sounds like float is sticking in carb,could be a stuck needle or a bad ...
dealership or auto parts store. Sounds like the guy who cleaned the carb system has messed up the float settings. Alternate to that, the float needle is stuck or left out when the carb was reassembled
29 questions posted
Usually answered in minutes!
652 Questions
453 Questions
469 Questions
316 Questions
292 Questions