1985 Yamaha XJ 700 X Maxim "surface carburetor" Questions

Ad

Question about Yamaha XJ 700 X Maxim Motorcycles

1 Answer

...surface. The bottom side of the carburetor (inside the bowl) has two jets that look similar and have identical threads, but the holes that go through them are not identical. The main jet is the one ...

Ad

Question about Yamaha XJ 700 X Maxim Motorcycles

2 Answers

...just dropped them in a can of carb cleaner rather than fully dismantlying and making sure every surface is polished and every oriface cleared. For any other questions regarding your Yamaha XJ ...

Ad

Question about Yamaha XJ 700 X Maxim Motorcycles

1 Answer

...surface located on the bottom of the carburetor to the edge of the float. On a 24 mm Mikuni card, the distance between the gasket surface and the float should be 1 inch. On a 20 mm Mikuni carburetor ...

Question about Motorcycles

1 Answer

...a mixing place for the air and fuel. If the mixture is not in appropriate proportions this issues surfaces. Many a times as the carburetor gets old, the jet, idling valve etc., may not function ...

Question about Yamaha XJ 700 X Maxim Motorcycles

1 Answer

...surface of the carburetor where the float bowl face is seated and tightened. - Adjust the float level by bending the float notch towards the needle valve (to decrease the float level and to raise the ...

Question about Yamaha XJ 700 X Maxim Motorcycles

1 Answer

...surface of engine cover, recently i have replaced petrol supply pipe but then also there is leakage, due to this i have lot of prob. because after filling petrol, due to leakage bike goes in reserve ...

Question about Yamaha XJ 700 X Maxim Motorcycles

1 Answer

...Measure from the carburetor housing gasket surface to the highest point of the float drum. The measurement specifications are (14.5 to 18.5 mm) or (0.57" to 0.72" in). Make sure the float pin ...

Question about Yamaha XJ 700 X Maxim Motorcycles

1 Answer

...whats the ideal position of filter if the sponge doesnot have two coloured surface. the wire mesh should be closest to the engine. it keeps the filter material from being drawn into the

carburetor float level is usually per bike. you can try to start at 16mm give or take 1mm this is the setting for a 1989 kdx 200/220. it is measured from the bottom of float to the mating surface just

...to cylinder is tight. (more daring diagnosticians have lightly sprayed fuel source to external surfaces to detect air leak...engine speeds up when fuel is sucked through air leak) Another ...

Not finding what you are looking for?
1985 Yamaha XJ 700 X Maxim Logo

335 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Yamaha Experts

vince

Level 3 Expert

2530 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1212 Answers

littlewheel

Level 2 Expert

122 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...