Question about Yamaha XJ 700 X Maxim Motorcycles
pooor acceleration after cleaning carbs on 1986 yamaha xj700 maxima ive reently removed and cleaned the carbs, after installing them the bike fired up right away which it never did before, but a ...
Question about Yamaha XJ 700 X Maxim Motorcycles
...adjust the level by using a long nose plier. Put the pieces back and install the carb. That should solve the leak. Let me know if there are other problems, please rate if this in any way helps, ...
Question about Yamaha XJ 700 X Maxim Motorcycles
Hi I have bought a 1985 700 maxim watercooled it has been sitting for appr 2 years today I took carbs out, disassembled them, cleaned them w carb cleaner and put them back in in addition to that I ...
Question about Yamaha XJ 700 X Maxim Motorcycles
without but have to manually hold the throttle until the bike warms up. What is the problem?? get a carb kit and service your carbs try choking it just a little bit instead of using full choke
Question about Yamaha XJ 700 X Maxim Motorcycles
problems after going through this around 4 times, or if you are never able to get the bike going, the odds are that the carburetors need a major cleaning/overhaul.Do not be dismayed. Go to www.xjbikes
...maxim fuel problem it hasent run since 1995 it still wont run with air pressure on the gas tank,the carbs look clean when i pulled the outside two carb top plungers off but only runs on carb medic ...
Question about Yamaha XJ 700 X Maxim Motorcycles
...bike off, for about 15-20 seconds. Doesn't leak while bike is running. Float stuck in one of 4 carbs. ???? I had the same issue, cleaned the gas tank, carbs removed, cleaned and tuned. It helped ...
...carb and screws into the brass needle jet. It's size is around 120. The pilot jet goes off to the side and its size is around 35. The threads on these jets are identical, but if you get them in the ...
Question about Yamaha XJ 700 X Maxim Motorcycles
...done first start your bike get a can of wd40 after your bike is warm and running spray around the carb jointsall 4 of them if your engine changes rpms up or down you have a intake leak ether your ...
Question about Yamaha XJ 700 X Maxim Motorcycles
..., then it starts to miss on that cylinder again' If This Engine Has Rubber Boots Between Carb And Intake Port(Head) The Clamps May Be Loose Or The Rubber Boot May Be Cracked Or Permeated( ...
335 questions posted
Usually answered in minutes!
652 Questions
453 Questions
469 Questions
292 Questions
290 Questions