...signal generator, located on the cranckshaft. 1.Stator produces A/C current 2. Rotor has magnets in it and goes around the stator and is part of the A/C current process. Rotor also has a raised spot ...
generator cover torque spec I'm looking for the torque specs for the generator (shifter side) cover bolts on a 1999 intruder 1500. The stator and signal generator sit behind this. 25 ftlb
...signal generator cover.2-use 17 mm wrench on signal generator rotor and rotate engine clockwise the "T" mark on the rotor should line up center of the pick up coil,to the left.3-there is a notch on ...
...and the other is signal out. By using a signal generator square wave out, you can check the speedometer. Sweep the output from 10Hz upwards and speedo should sweep. Check at plug where sensor
...turn signal the bike will not flash and you here a buzzing sound comming for the pulse generator . And when I use the right signal it works just fine . So how should I shoot this ? new flasher ...
how do i install a new points set on a gs 750 The 1981 Suzuki GS750L does not have contact points. It uses a signal generator instead.
turn signal use generator lite is on, guage flutters Not a problem , most boxers do this unless you change the voltage regulator to upgraded solid state version that charges quicker at higher voltage
...have replaced coils and plugs also pickup rotor and signal generator. still no spark to plugs the primary side of coils have 12v drops to 9 when trying to start. Use a digital multi meter to check
ENGINE HAS NO FIRE, REPLACED C D I STILL NO FIRE Check for bad earth often over looked, test coils with multi meter omhs for resistance, test kill/ignition switch and the signal generator for the cdi.
73 questions posted
Usually answered in minutes!