...timing light, etc., etc., until is is set where it should be. There will be a mark on the center case that the magneto marks will line up with if there are indeed marks on the magneto. It would ...
...175 run for a day. It started back firing through the muffler and will not start again i think it is out of time but it is fireing good through the spark plug. I need a website that gives me a manual ...
175 it floods when the gas tank line is conected to the carb.when i un hook it and let it sit it will start and run great untell it runs out of gas. obviously it is flooding. but is the cause the carb
valve timing of elemenator 175 set them on top dead center.
...set / oil pressure gauge is low at idle but goes over 32 when rev'ed. 12100 miles. killed once and Black smoke seemed to come from air intake area. Has power commander on it and BuB ...
Question about Motorcycles
...175 carburator pilot screw, how many turns out? Thank you Start with 1.5 out and fine tune it from there for best idle. Hi, Daniel the carburetor throttle shaft wheel has two cables the cable closest ...
...the entire system for several hundred dollars. Usually between $800-$1000. You can get after market sets of the component parts and do it yourself and that's the only way I know of to avoid the cost ...
...Now use a timing light to set the timing. Set the timing at idle by rotating the points base plate left or right as needed. Rev the engine to see the timing marks advance due to the spark
110 questions posted
Usually answered in minutes!
42 Questions
27 Questions