...clean all the parts. If carb is not too dirty, leave the jets and mixture-adjust screws alone (otherwise will have to re-adjust later). 2) Overflow tube is plugged (hence fuel in the cylinder instead ...
...carb apart and either clean it well or put a carb kit in it.Very inexpensive and your carb will work much better. what is happening is the needle and seat are sticking and causing the carb float not ...
yamaha sat for two years cleaned carb and gas tank idles fine but when it warms up it back fires thru carb what might be worng it is a atv big bear 350 1987 500 miles Check valve adjustment. And...one
hi i have a yamaha fino scooter.. and it wont start. i've cleaned the carbi. changed the spark plug. checked that thers a spark. bleeded the feul line. and adjusted the throttle and idle. any ...
Question about Yamaha DT 360 Motorcycles
carb, removed the bowls, and thetops. Looks pretty clean. Needles are a little dirty and one of the cyllanders is a little dirty but nothing major. Ideas? The engine feels very dirty where the intakes
...carb cleaner it idled real hi 5000 rpm it wont run now the strange thing and this is why i replaced the coil we could get spark thur a bulb type spark tester but when we grond the spark plug to the ...
Carb is clean, all passages are open. Occasionally, there is a backfire out the exhaust, and then the engine starts on the next kick, but still only runs a few cycles. There seems to be no response to
carb is clean, if it doesent flood out the overflow they are usually OK A nice clean and relatively new air filter can help. the float needle can wear, so you may be able to drop the float level a bit
Question about Yamaha DT 360 Motorcycles
...clean it up. any ideas and suggestions to make it run like it's supposed to would be great. the carb piston slide has a needle in center lower the retainer clip on needle to richen fuel here a carb ...
...clean the carb, make sure you also clean the choke pickup tube or it wont choke. also make sure you have the slide installed in the right direction ( not backwards and the idle is not set too high at ...
110 questions posted
Usually answered in minutes!
42 Questions
27 Questions