...seat. Now turn each adjuster one and one half turns outward. Put the rest of the carb back together, clean the air filter and install the carb. Let the float bowl fill then start the engine. This ...
...are revealed. the front of the seat is not bolted it just slide out. when you put it back on, put some white lithium grease on the front seat attachment fork piece to eliminate rubbing/squeaking ...
...back of the seat down a hole. Re-attach the two halfs of the seat at the front but this time one hole up. You should see a gap between the two halfs. Put the rubber gromets back on, this is where I ...
...seat cover back on it will not show the lines where the gel is at. put your seat cover back on and start on the sides of the seat 1 #2 and #3 put a staples in 2 3 there start ontoward 4 the front of ...
slot in the frame at the front of the seat. When you put the seat back on, push down while sliding the seat to the front. Make sure the tongue is in the slot before you reinstall the bolts at the rear
...seat back on the bike to do a fit check until you've reach the seat height you want. Cutting the seat down this way will allow the next owner to easily build up the seat from the bottom and not mess ...
Question about Vento Rebellian Motorcycles
...back off 1/2 to a full turn tighten down jam nut 6-10 ft.lbs. put cover on,go to cable mid-control and adjust till you have a 1/16 to1/8 freeplay at clutch lever (use a nickel) squeeze handle in at ...
...back and forth from a solo with bags to a dual seat and absolutely love this ride. Also put a Mikuni 42mm Carb and KB Pistons and thats all folks and she rides great with all the power you ...
Question about Vento Rebellian Motorcycles
...seat. Pulling back on the pillion after removal of the hold down bolt usually releases it. The brackets to hold the saddlebags straight and away from the rear tire/ brake disc. Mounts with shims to ...
Question about Vento Rebellian Motorcycles
seat hinge up enough to loosen the 10mm hex head bolts on the sides of the hinge with a box end wrench. Don't drop the 10mm bolts though because they can fall down onto the tank near the fuel pump and
32 questions posted
Usually answered in minutes!
58 Questions
11 Questions
9 Questions
6 Questions
6 Questions