Question about Triumph Bonneville America Motorcycles
stuck in. I can pull it out with needle nose pliers but when I apply brake it stays in. First check the O-rings/ seals on the piston, clean gum or dirt from the piston then bleed the brakes. Check for
Gl1800 "08" rear brake has stuck on and melted the piston seals and brake lines and R/H pannier, ABS has no fault codes. You will need to replace the caliper and brake line. Check the linked braking ...
...pistons. Chances are the rings are just stuck in the piston ring grooves. Sometimes they can be freed up by the mechanic manipulating them. Often they break when manipulated. It all depends on how ...
I ran my TT-R125 ymaha out of oil and thought I locked up the piston. Took the engine apart and the piston was fine. The kickstart wont kick over and I cant figure out what is wrong. can you turn the ...
Question about Triumph Bonneville America Motorcycles
cant get piston out of front caliper on suzuki 1200 k4 bandit I'm assuming that it has been sitting for a while and now it's stuck. Do you have oil in the reservoir? Pressing the brake lever should be
Question about Motorcycles
replaced rings and honed the cylinder but its scored up again and the rings were stuck in the piston and were hard to remove This is a Honda GC160 5 hp engine. I just finished putting in new rings and
we have a Suzuki 50cc quad with automatic start. When you go to turn it and nothing. husband said the piston is stuck and it wont turn , not enough power. How can we fix that If the piston is seized ...
NO COMPRESSION blown rings, bad piston/cylinder tolerance, valve stuck open, spark plugs loose, hole in piston. be more specific.
STUCK PISTON ON 65KX KAW sounds like a siezure, tear down the top end and inspect it! hopefully its just the piston and not the crankshaft. remove the piston and see if the rod has nice smooth ...
Question about Triumph Bonneville America Motorcycles
stuck .... Corrosion develops inside the caliper and causes the piston(s) to stick and fail to retract when the brake lever is released. What you will need to do is remove and disassemble the calipers
43 questions posted
Usually answered in minutes!
53 Questions
44 Questions
40 Questions
33 Questions
36 Questions