Question about Suzuki GSX 1300 R Hayabusa Motorcycles
... bad like!!! the problem is,, you need a new cluch fitted to the bike which is far from cheep to get repaired,,,,,and its a big job too, i hope this has put you right,, good luck,,from1 biker 2 ...
Question about Suzuki GSX 1300 R Hayabusa Motorcycles
put in a new clutch master cylinder caliper on my 1996 Honda Shadow Spirit 1100, the fluid is not going down from the clutch reservoir to the caliper Make sure the bleed screw on the slave cylinder is
Question about Suzuki GSX 1300 R Hayabusa Motorcycles
want build pressure put on a new slave cylinder.no leaks anywhere. THIS SYSTEM WILL NEED BLEEDING AS WOULD A BRAKE SYSTEM USING BRAKE FLUID. THERE IS A BLEEDER SCREW DOWN AT THE SLAVE FOR THIS PURPOSE
...put it on centerstand and it shifts gears just fine. is it my slave cylinder as i know my master is good and i have bled lines have very good pressure at handle but cant downshift. please help. ...
Question about Suzuki GSX 1300 R Hayabusa Motorcycles
...new fuild and spit it out. Next top off the reservoir near the clutch handle. Seal the lid tight. Put the bike back on it's kick stand. Next do this about 10 times. 1. open bleers. pump clutch. close ...
Question about Suzuki GSX 1300 R Hayabusa Motorcycles
...new o-rings for the clutch slave cylinder . Then you should get enough pressure in the system to operate the clutch. Often a wet clutch that has sat for years will have the plates stuck together. One ...
put in gear. the bike has 75k and runs like new, the discs looks like new . i cannot see what part on the clutch assembly will create pressure inside the basket setup. any help is appreciated, Hey End
Question about Suzuki GSX 1300 R Hayabusa Motorcycles
...and the brakes were fading.He wasn't sure if they put any new parts on the bike or just flushed the system.Main thing was though,after the bike got hot,the clutch faded to nothing.I hope this helps ...
Question about Suzuki GSX 1300 R Hayabusa Motorcycles
...put new in . where is the bleeder located. remove the old fluid from resevuar with a small hose, refill with new, and bleed out the old that is still in the line.keep an eye on the level as you bleed ...
Question about Suzuki GSX 1300 R Hayabusa Motorcycles
...new clutch because when I pulled the clutch lever it only had about a inch before disengaging and reengaging but it still that way anyone now why Hi,try bleading the fluid for the clutcs so theres no ...
55 questions posted
Usually answered in minutes!
41 Questions
41 Questions
25 Questions
22 Questions
15 Questions