...2) Is a gasket sealer recommended and if so is it applied to both the cover and the engine side? (when I removed the old cover it appears as a sealer / adhesive was attached to the cover side only). ...
...2-3-4), tighten the head bolt in three stages. 1. Tighten each bolt to 7-9 foot pounds of torque. 2, Tighten each bolt to 12-14 foot pounds of torque. 3. Mark each head bolt and head with aligning ...
Question about Suzuki DR 650 SE Motorcycles
head, then the #2 bolt is the left rear bolt, #3 bolt is the right front, and #4 bolt is the right rear as viewed from the top of the head. On the rear head, the #1 bolt is the bolt at the left rear,
...head bolt torque specifications are typically as follows: 1. **Initial Torque:** 29 Nm (2.9 kgf-m, 22 ft-lbs) 2. **Final Torque:** 64 Nm (6.4 kgf-m, 47 ft-lbs) It's essential to tighten the cylinder ...
...pitch.......6 lines on the head of a bolt indicates a grade 8.......I think the ASE grading is the number of lines on the head of the bolt + 2......Be careful, a broken bolt hazard is
...and limits. Good Luck Try this Triumph forum. They discuss using new bolts vs old after removing head and the sequence and torque specs. ...
head bolt torques 2 stroke i know the sequence not the torque The Kawasaki service manual says to torque the cylinder head nuts to 25 N-m.
Question about Suzuki DR 650 SE Motorcycles
head cover bolts 10 1.0 2 Exhaust pipe joint nuts 21 2.1 3 10 ... Crankcase Torque Spec.?? - CRF250R & RX ThumperTalk https://www.thumpertalk.com > forums > topic > 8357... Nov 5, 2010 - 12nm, 9ft
23 questions posted
Usually answered in minutes!
6 Questions
5 Questions
4 Questions
2 Questions
2 Questions