1993 Suzuki RF 600 R "extreme" Questions

...will tighten up and slacken with one rotation of the wheel chains & sprockets are subject to extreme forces & adverse conditions.adjust chain to recommended specs at the 'tight spot',with ...

gas pressure rear shock amount of nitrogen gas in rear shock The gas shock uses an extremely high pressure depending on the shock anywhere from 145psi to upwards of 200psi, they can be extremely ...

...This is a dangerous thing as they will come out with serious projectile force,. so you MUST BE extremely careful, utilize a stationary vise and a board in pace to reduce the throw out - the

...tend to skid out on a corner. Set your front and rear shocks to drop together , that is best for extreme riding conditions (you never know when an extreme riding conditions will surprise

i have a vespa GT125 which is extremely sluggish i have a Piaggio Vespa GT125 which is extremely sluggish for about 20 minutes only reaching 40-50mph then it kicks in and becomes as nippy as i would ...

The bike starts and idles fine, but once a load is out on the engine it revs extremely high. I then back out the fine adjustment idler screw and the engine rev's down enough to put iinto gear. ...

clutch not disengaging Clutch not disengaging when clutch lever is depressed. Assuming the clutch cable is intact and adjusted properly at the handlebars, the normal things that would cause the clutch

Yamaha 2005 150 HPDI wiring diagram Looking for wiring diagrams for digital tachometer with trim indicators and warning signals. Mine had the plastic trip arm break. No trim reading on Tach face. ...

I have 2007 suzuki intruder the front spark plug was replaced 3 times due to intermitant spark.Each time i check the spark plug no spark then replace the plug then spark then runs for short period the

...to FixYa, Almost always, seated on the bike the lefthand ignition coil supplies cylinders 1 (extreme left) and 4 (extreme right) while the right hand supplies the mid 2 & 3. Good luck and ...