...add stress to some component. Bigger bore will give more 'grunt' but may require bigger valves & carb. This in turn will increase pressure on small ends, conrods and crank big end plus your oil pump ...
...wind resistance. Keep the chain oiled. Change gearbox oil every 2000 miles. Please note that you may need to add a link to the chain in order to use the larger sprocket. Please rate my answer.
...add oil to the tank in an effort to remedy. This resulted in us getting approx. 4 litres of oil from the sump during our initial draining! We renewed the oil filter and put 1700 mls of fresh oil in, ...
...oil might be bypassing the filter a lot more often than thought. Heavier oils increase the back pressure just a bit more and that adds to the likelihood that the bypass gets tripped allowing oil to ...
oil level half way between the add and full mark when hot. 2. Run oil breather lines from the head into a TEE fitting below carb/induction module then a single line into a mini filter under the frame.
oil is used and changed regularly. Any ideas?? Thanks I'll bet you replaced the "fiber" plates only in which case you need to either take the steel plated out and have them sand blasted, or preferably
...add very small amount of engine oil to plug threads, using only the plug socket and extension bar by hand thread the plug back into the motor until it stops , then add the ratchet onto the extension ...
oil from the frame and engine and add 1 qt, perhaps a HAIR over, but not 1.5qts. 1.5qts is always too much for ours, I barely go over 1 qt. We have about 18 Dales in our group that we ride with, so we
15 questions posted
Usually answered in minutes!
329 Questions
228 Questions
165 Questions
158 Questions
169 Questions