Question about KTM 450 EXC-R Motorcycles
Crank engine crank case too full and gear case section empty of o Drained the oil the other day on my 08 450 exc and found a piece of seal in the oil as well as metal, when i removed to fill plug oil ...
Question about KTM 450 EXC-R Motorcycles
What is the torque spec on ktm 65 2010 crank shaft nut holding primary gear. thanks check google should find it on there
Question about KTM 450 EXC-R Motorcycles
...Crank Shaft Width tough question there
specs like that may be in the repair manuals
you measure shaft widths with a slide caliper or micrometer
check out this youtube
Hi, Neil ...
Question about KTM 450 EXC-R Motorcycles
...crank shaft extension, double sprocket, sliding cam, and a stiff spring together form a "compensating sprocket". When a cylinder fires, the power stroke is smoothed out by the action of the ...
...crank shaft until the engine is on top dead center compression stroke and the lines on the cam shaft gears are even with the top of the cylinder head. At that point evenly loosen the bolts that hold ...
...First you need to be absolutely certain where top dead centre is. Usually you can get this from the crank rotor markings, or do it the old fashioned way with a long bolt down the spark plug hole and ...
...shaft, bearing, and the cam chain, n tensioner. The flywheel was stuck on pretty good but eventually came off with the puller. It had a very small amount of rust on it and the stator looked fine. I ...
...crank shaft and use a wire pointer, you put the home made (or factory tool) in the spark plug hole, you gently rotate the motor in one direction then the other, until it just bumps the tool, TDC will ...
...shaft bearings to the gearbox. Unfortunately it can be worse than this because if the housing that the bearing sits in allows the bearing to move, then it can become oversize - allowing the whole ...
50 questions posted
Usually answered in minutes!
52 Questions
45 Questions
33 Questions
25 Questions
26 Questions