...older un-answered questions trying to make sure your issue was resolved. Usually 2nd gear whine is caused by bent shifting forks or dogs and the gear is wearing incorectly. The best solution is ...
...shift hard on a 91 CBR 600 f2 Weak Transmission "bent shifting Fork" shifts on it's own due to The Bent fork and Engine Vibration,,"DANGEROUS" Repair Immediately,,"Split the Cases to the Transmission ...
...bent my shift arm then when i tried to replace i had to move the clamp piece that goes on the transmission so the rubber piece the connects to the rod the goes down there wouldnt rub against the bike ...
Question about kawasaki Motorcycles
...but will not shift into second gear. could this be due to the shift fork? Yes, a bent shift fork could cause this. A clutch dragging too much can also make shifting hard, as well as spent motor
cause of this? There are a few possible causes. A slightly bent shift fork, the index wheel on the shifter not operating properly, and rider error are the usual causes. I doubt you are failing to lift
...cause of not selecting a single gear is a bent shift fork. Shift forks in motorcycles are what pushes the gears in and out on the shaft to engage them. Rough shifting or missing gears can sometimes ...
...I figure out which one it is? A broken gear will make a clicking noise each revolution of the gear. It will not cause the bike to slip out of gear. The problem sounds like a mildly bent shift
Question about KTM EXC 525 Racing Motorcycles
bent shift fork. While accelerating you can feel the power cutting in and out quickly. The problem will get worse if you keep pushing 2nd gear till it slips. You can learn where (at what RPM) it wants
...has not been bent in your efforts to shift gears. The cost of 6 or 7 quarts of oil and an oil filter is nothing next to the cost for replacing bent shift forks. Please rate this solution. Thanks
Question about KTM EXC 525 Racing Motorcycles
...bent,could this cause a huge problem? A bent shift fork if pushed, will continue to bend. As this happens that gear will pop out at lower RPMs, eventually that gear will not stay engaged. You can ...
24 questions posted
Usually answered in minutes!
3 Questions
4 Questions