2004 kawasaki ZZR 1200 "adjust cam chain tensioner" Questions

...cam chain tensioners are sticking. you would also be better off giving the bike some serious throttle at times as this stops the adjusters from sticking, my advice would be to take it out for a ride ...

...rattle disapears after about one minute this could be a sticky cam chain tensioner as the oil gets hot it releases the adjuster to work normaly. 2 bolts it if you wish to take it off and clean

...adjust timming chain on fz600 1986 and if there are any torque requirments Most likely you have anautomatic cam chain tensioner, which cannot be tensioned, and the only remedy is to replace the cam ...

...Cam chain tensioners pretty sure its the cam chain tensioner springs. lost their spring If its been making this noise for a while what else would i need to replace. cam chain? tensioner springs? cam ...

...of the bike you may need a new cam chain. There is nothing to adjust so you need to just figure out if the chain is stretched , if a guide is broken, or if the tensioning mechanism is

cam chain type noise. could this be a worn cam chain tensioner . the bike has covered 36000 miles it can either be a worn tensioner or need for a valve adjustment. if you rev the engine and noise goes

Cam Chain Bike is a 1996 ZX6R. Cam chain is very noisy. Removed tensioner and it seems to work fine. I saw manual adjusters on ebay. Is there more adjustment in a manual one? Could I get the seaon out

...adjust cam chain tensioner in kawasaki EN 500 1992, if not is it possible to fit manual cam chain tensioner. no, it is automatic adjustment only, once it has reached it's end, you must replace the ...

...adjust the cam chain tensioner: disconnect the negative lead to the battery, remove the ignition cover plate on the right side of the engine, using the 17MM bolt rotate the engine CLOCKWISE 2 full ...

...adjust the timing chain of a 1986 honda shadow vt500 without taking the motor off the frame? According to the official Honda Service Manual there is no adjustment. If the cam chain is worn/stretched, ...