2004 kawasaki ZX-6R "cam chain tensioner tighten" Questions

the timing chain where is the tensioner and proper procedure to tighten the timing chain It has an automatic cam chain tensioner. If you are getting cam chain rattle, I would look at worn guides/chain

...cam chain is rattley how do i tighten it ive a 89 zxr 400 There is a cam chain tensioner on the ZXR 400. It sounds like you need a new cam chain.Important Note: The cam cahin tensioner is held on by ...

...cam chain tensioner cleaning My bike has started making clicking noises and I heard if you clean the cam chain tensioner it will stop Never heard of the cam chain getting dirty. There is a mechanism ...

cam chain noise on a CBR1100 from 1998 Can this be ajust ? if so where is the bracket on the engine Cam chain normally must be replaced, but sometimes cam chain tensioner may have some space to put ...

...cam chain on xjr400 If you need to tighten your cam chain then it sounds like the automatic tensioner might need loooking at as it isn't functioning correctly, or your chain needs changing if the ...

cam chain tension and how to set it . There is some cam chain noise at low engine rpms. bike is a 1982 maxim 550 Yes, it is the cam chain tensioner. With the engine off, just loosen the tensioner lock

...cam chain tensioner: disconnect the negative lead to the battery, remove the ignition cover plate on the right side of the engine, using the 17MM bolt rotate the engine CLOCKWISE 2 full revolutions, ...

cam chain tensioner. Find the timing marks for the motor and set the motor to top dead center (TDC) on the compression stroke for the #1 cylinder. Piston up, both valves loose (not pressing on valves)

...cam chain adjuster does not lock After removing tensioner cover, tightening the adjusting screw (should be automatic) to just elinate cam chain noise does not lock. Is it safe to remove the tensioner ...

...lots of notes, white out pen marks on the cams, perhaps a photo or two. Valves clearances normally tighten up, so it may be cam chain noise, even if it appears there is still some tension ...