i have a carburettor in pieces of a 1998 i have a carburettor in pieces of a 1998 kawasaki kx60 would like to aquire a diagram of this carby to check if all parts r there and to rebuild it thank you ...
i have a kx60 but it takes 10 minutes to bump start it then it keeps boggin out . make sure the spark plug is good and if it is then the carburetor may need cleaned or adjusted
I have a kx60 I've rebuilt the top end & the I have a kx60 I've rebuilt the top end & the pusher clutch pin was missing I replaced that, all parts are there but the clutch still wont engage, ...
torque spec on kaw. kx60 cylinder head bolt set it between 18 and 20 lbs do this on cold settings
...60 crank have parts need to install crank and bearing What is the question? Are you trying to put KX60 crank in a KX65? If so, I am pretty sure that won't work without a lot of
how to install vforce 3 on kx60 2002model. Seems that the reed block hits clutch adjustment on side of barrel. Are any mods needed. This is for a 60 not 65. Had to choose kx65 onthis site as there was
I have a kx60 and I can't get the Back tire to get tightened Not really sure what you are asking, but...if you mean that the wheel wobbles after you tighten the axle nut, your rear wheel bearings ...
I need to replace the cluch cover on a kawasaki kx 80 See: https://www.cyclepedia.com/1988-2004-kawasaki-kx60-kdx80-kx80-kx100-online-manual/
Question about kawasaki KX 250 F Motorcycles
on a kx60 crank can you have play up and down very little play thanks NO! you should have no movement! needs bearings!
111 questions posted
Usually answered in minutes!
47 Questions
16 Questions