...stand and removed the plugs, put it in gear and tried to turn the rear wheel. I cannot move this. Any suggestions????? Heeeeeellp!!! Des. Hi and welcome to FixYa, A few ideas: The buzzing/vibration ...
...working but there is a back light. plus bike still running at 2000 rpm. Suzuki advised ? high resistance and advised pulling the wiring loom apart at junction on left side as may be corrosion, they ...
...stand the bike straight up and remove the derby cover. Check the oil level in the primary. It should be no higher than the lower edge of the outer clutch basket. Loosen the lock nut in the center of ...
stand .well. but breaks down around 4k rpm on test run. like its fuel starved but when plugs are pulled they look fuel fouled??? Hi It would help if you knew why it stopped years ago, wether there was
...stand the bike up fairly straight up to do this to make sure you don't have any oil running out of the primary. With the derby cover off, you'll see the clutch pressure plate. In the middle of the ...
...Stand the bike up straight and remove the derby cover from the primary cover. In the middle of the clutch assembly, there is bolt with a locknut on it. Loosen the locknut and turn the outward a turn ...
...resistance. However, if reconnect to linkage, throttle will not move. Bike has been sitting in shed for number of years. hi sounds like the main spindle shaft that operates the carbs has seized spray ...
Question about kawasaki ZZR 1200 Motorcycles
...working on bike. When this happens, do you here the fuel pump running for a few seconds when turning on bike? If not, then more than likely it will be your run/stop switch. I say this because you are ...
...resistance again. When you remove the sending unit, always replace the gasket that goes beneath the unit. Be very careful, you are working with gasoline and expolsive fumes. Do not smoke or have any ...
...bike runs ok on the primary jet until it needs more fuel from the main jet. Does it smell rich when running? - caused by large fuel drops not airated by the emulsion tube above the main jet. Could ...
25 questions posted
Usually answered in minutes!
17 Questions
9 Questions
2 Questions