mixture screw. try turning it out a quarter of a turn and see how it runs. out = more air in = more petrol causing black soot on plug. you will notice lots of smoke out of the back if your oil mixture
acceleration has good compression starts first kick hot or cold to eliminate bog must seat mixture screw to seat the screw it goes all the way in but only 2.5 turns out adjust more if needed good luck
...mixture screw 2 turns out, from the fully turned in position. The starting proceedure is as follows, when the engine is COLD, turn on fuel, pull on the choke fully, and kick the engine over. DO NOT ...
...screw on the bottom of the carb unscrew it a few times make sure fuel flows from the bottom of the carb if it don't check your needle and seat make sure the ruber on the end of the needle isn't ...
...screw and mixture screw the screw that is th smallest and the furthest in is the mixture screw you will reccomend a manual to adjust the mixture in the manual it will say e.g.mixture screw: 1 1/2 ...
...mixture screw. jot that info down. Then remove the mixture screw and spring. spray carb cleaner in the hole for the mixture screw, using the straw that comes with the can. this will ensure you have a ...
...mixture screw i have a cr 125 r 1997 with kehein carrbie need 2 no how to adjust the fuel mixture screww Begin by screwing the mixture screw in all the way until it stopps,,,but ONLY JUST ...
...mixture screw all the way in then back it out between 1 1/2 turns to 2 turns that will get the engine to idle from there set the idle speed with the throttle screw to desired idle rpms now turn the ...
starts first kick hot or cold i can make it go away but must completely seat mixture screw checked airfilter and intake you might have to make sure that the carb is clear of any gunk ( very important
326 questions posted
Usually answered in minutes!
29 Questions
21 Questions
7 Questions
6 Questions