...clutch slips in the lower gears, but not consistently. Coul that mean some wear on some or all of the plates and friction plates? From what I have researched, it doesn't look like a difficult job. ...
...clutch plates are bad, try to replace the clutch plates it might work... Kickstand switch is bad unhook it and tie the wire together and itkl take care of it had yhis happen to 2seperate motorcycles ...
Question about kawasaki VN 800 Vulcan Classic Motorcycles
...put the bike in gear, hold the front brake, and slip the clutch a little to remove any built up or stuck crud on the plates. Other possible cause,improper free play adjustment,notched clutch
Question about kawasaki VN 800 Vulcan Classic Motorcycles
clutch plates go in and are thn driven especially those notches, check too the gear that mashes with the clutch system for any wear and not bad to check the springs too in the clutch basket. Hope this
Question about kawasaki VN 800 Vulcan Classic Motorcycles
Well I removed the clutch casing. I wasn't to sure what I was looking for. The nuts on the clutch plate where not loose though the timing chain was "to me " very tight also the plastic guide bar did ...
Question about kawasaki VN 800 Vulcan Classic Motorcycles
clutch plates and springs need replacing. My gut tells me it's first gear's cog, but you say it was changed. It could be a recurring problem - maybe bad machining from the factory. But if it only does
Question about kawasaki VN 800 Vulcan Classic Motorcycles
...If i don?t give it full noise its ok. It is strange as i am thinking, if it is the dog clutches it should jump out and stay out, but this jumps out at say 3/4 revs and jumps straight
Question about kawasaki VN 800 Vulcan Classic Motorcycles
...50 km but sounded really rough at high speeds around 120km. Pulled over to park in parking lot held clutch in and it stalled noticed a little puddle of gas underneath. Started it later rode for a bit ...
clutch plates. Mount the outer clutch basket and the inner clutch hub then install a fiber plate, then a metal pressure plate, fiber, metal, fiber and so on. You should end up with a fiber plate. Some
Question about kawasaki VN 800 Vulcan Classic Motorcycles
clutch plates are inside A 1990 suzuki dr650s Reading from my manual (Suzuki Service Manual) Primary drive gear (the clutch "basket") Spacer Clutch pressure plate Clutch drive plate (has friction pads
91 questions posted
Usually answered in minutes!
67 Questions
52 Questions
27 Questions
27 Questions
24 Questions