Question about kawasaki ZX-6R Ninja Motorcycles
like a loud ticking when starter button pushed, I changed the bushes in the starter motor, and it fired up 1st time. Check that first (you will need new o-rings if you take the starter out and appart!
...starter button it will turnover a few times and then a huge clunk sound and it will stop. it will act as if the starter is seized for a min then if i try it a few more times it will turnover no ...
starter button pressed,as soon as released bike cuts out this is very rare. if the engine kill switch is in the same grip, check it , it may be shorting/ loose/ defective. only other possible thing is
...button all power fails and a click noise is made i checked two terminals and they both have a power and a ground at the same time is that possiaable? it a 2006 not a 2001 how old is the battery? sure ...
...button you should be sending power to your solenoid which sends power to the starter motor. If your stator/ rotor cover seal is bad, water may have got on the stator and corroded. If it filled with ...
Question about kawasaki ZX-6R Ninja Motorcycles
...starter button. I took the starter button out of the loop (disconnect) and it will still try to start. Could this be a bad starter? Or can it be a short somewhere in the wiring? The starter button is ...
Question about kawasaki ZX-6R Ninja Motorcycles
starter button is designed to turn the headlight off when pushed in halfway so all the batteries electricity goes to the starter. The starter button is a two position switch. The starter button may be
...starter button nothing happens. Could there be a blown fuse. All 10amp fuses good Chances are that that problem is not fuse related. It is more likely you have a defective starter button. The starter ...
...starter button is a two position switch. The lights are supposed to go dim when the button is pushed halfway in. When pushed in all the way it should activate the starter solenoid. The starter ...
Question about kawasaki ZX-6R Ninja Motorcycles
...starter button . With a voltage meter on the wires from the harness you should have continuity.Reconnect the wires. Push the starter button, if you hear a click from the solenoid the button is good. ...
216 questions posted
Usually answered in minutes!
84 Questions
79 Questions
64 Questions
51 Questions
51 Questions