2001 kawasaki KMX 125 "split case put seals" Questions

...case gets split then all the gears and shift drum and shift forks come out. Remove the crank and then the bearings and seals. Install new bearings and seals and also a new sprocket shaft left bearing ...

...with out damaging the case. If you have to split the case to get them out you may as well put in the good seals. At any rate, if the seals have flat outside edges you do not have to split the

...split the engine case? Factory service manual doesn't specifically cover the procedure. The manual on the 750 says put new seals on the crank as you install it, and I believe they have a locating lip ...

...case have to split? It leaks oil. Also is the flywheel extractor size for the sem ignition M26-1.5 pitch the model is 1994 250 exc us thanks kevin case needs to be split put a self taping scriw in to ...

...Split the case leaving the gears on the shafts and the shift drum and forks in place but out of the gearbox. Remove the crank and then remove the bearings from the crank or from the center casings ...

...seals in the diagram below are separated by the casing they fit into. The impeller is threaded to screw onto the impeller shaft. I think you already knew that by your "holding the tire" note. The ...

split the center case and clean/re-seal the case halves. Be sure to install new crank seals. New crank bearings? If 2 stroke oil, just put a cup of gas in the crank to thin the oil, rotate the crank a

...case gasket go bad and cause this same problem? I hate to split the cases for nothing? is your intake boot cracked? when it is idling, spray carb cleaner around carb and intake. If it revs, it is an ...

split the engine cases just because you can't get good throttle response. could be related to TORS, specifically the safety switch in the clutch/park brake assembly. If it's defective the engine won't

...split the case to get the conrod out. Here's what you can expect to change, probably the piston and barrel. If the piston does not have lines on it and the rings still fit tightly in the grooves, you ...