...allows it to pass emissions. i would disassemble and clean the carbs out with carb cleaner and a small brush (i use the ones that come with shavers) remembering to remove the jets and clean them ...
Question about kawasaki KMX 125 Motorcycles
...screen over the hole and use a sharpy to mark it's edges. remove the screen and take a drill with a small bit ( < 1/8"). Pop a few holes in the area of coverage of the screen and around the hole. ...
removed small pipe plug on bottom of engine I was changing my oil and talking on the phone and accidentally removed a small pipe plug under engine and fluid came out. What is it? should have been ...
Question about kawasaki KMX 125 Motorcycles
...comes on for 2-3 seconds and then goes out. How do I pull and interpret codes? Thanks. There is a small tube behind the air filter cover. There is a rubber piece covering the tube. Mine was doing ...
...sprocket. It can be difficult to get off due to the strong magnets in it. Once off, there are four small bolts holding the stator on and two small screws holding the plug into the case. Installation ...
Question about kawasaki KMX 125 Motorcycles
Coolant leaking thru small hole in bottom of engine. What would cause coolant to leak out thru the small hole in the bottom of the engine next to the drain hole?I have replaced the mechanical ...
Question about Motorcycles
Changed coils on Harley now it won't start just pop or small backfire! Changed coils on Harley now it won't start just pop or small backfire! Please remove sparkplugs and hold them on engine ...
...is bad or it could be you have a crack in the gasline that goes into the gas tank or maybe a small crack in the gas tank .... these small cracks wont allow any pressure to build up in the tank ...
...What type of oil do I use There should be a plug up on the frame near the steering, it is quite small and you will need a small funnel. Use four stroke motorcycle engine oil 20/40( not car oils ...
Question about kawasaki KMX 125 Motorcycles
...etc and crank shaft also if the crank isnt ballanced propally it will seize it but there is 2 the small end bearing or big end bearing the small end is on piston and big end is on crank which one ...
86 questions posted
Usually answered in minutes!
37 Questions
34 Questions