...try draining the carb fuel bowls, into a clean container and check for brown residue or water, there will be a small drain screw on the bottom of each carb and this will allow clean fuel into the ...
...who worked on it...Keep all fluids topped up....if you had blown gasket your oil would be a milky brown...Good luck to you ...
...brown residue,, pull off the plug cap from the spark plug,, ,, then unscrew the cap and just snip a little bit of the ht wire off,, so u see a copper lookin bit of wire pokin out the middle of the ...
...brown residue out of all the small areas and orfices. then with a large suction/pressure pump bought at NAPA I forced good quality dot 4 fluid through the lines untill all the fluid came out clear ...
Question about kawasaki Zephyr 1100 Motorcycles
...brown residue out as well, ,while the tanks off n stuff, one at a time pull the plug cap off ,, unscrew the cap from the ht wire,, and just snip a liitle bit of the wire off ,,just so u can see a ...
Question about kawasaki Zephyr 1100 Motorcycles
...residue may have caused the problem initially without me noticing. Anyway I would like to get the motorbike (buttercup) looking nice again. The bike is a Vulcan 1500R canary yellow. Thanks in ...
Question about Honda Motorcycles
...brown residue inside arb, GENTLY scrape it out it its solid - without scoring the aluminum.. so the oring will seal well. Do not use any rtv/silicon, this is a low pressure system and good viton ...
...the plug ? it should be dark brown and not too much black oil residue ! are the carb settings correct ? what compression do you have , 100psi or above is good but less than is bad for two strokes !
tank and check for water residue (brown)... siphone the fuel back to the tank. assemble and install the carburator and you'll be off to a cleaner burn. Also, make sure that the spark plugs are cleaned
14 questions posted
Usually answered in minutes!
16 Questions
11 Questions
4 Questions
2 Questions
1 Questions