...problem spark plugs get busted everytime and smoke are so visible in the pipe IF the runs with no power and smokes bad you need aring job ,or a valve job or both,but you got to tell me more so i
Question about kawasaki GPZ 500 S - GPX 500 R Motorcycles
...charged Hi and welcome to FixYa, A couple of initial checks: loadtest the battery; check, clean power terminals, connectors; check, clean fuse & fuse holder in starter relay and in fuse box; ...
Question about kawasaki GPZ 500 S - GPX 500 R Motorcycles
...like the installation of the tank is pulling on the wires causing a momentary disconnection of a power wire. Alternate to that, are the spark plug wires grounding against the tank? Please rate
Question about kawasaki GPZ 500 S - GPX 500 R Motorcycles
Hi, i have just put a gpz 600 motor into my gpz 400 frame, perfect fit with more power. But there are two holes on the side of the motor right with the cooling fins that is leaking coolant very slowly
.../ terminals; check / clean / tighten fuse & its fuse holders; check / clean / tighten major power connectors, wiring; temporarily bypass the safety interlocks before starting; or pull clutch ...
...knocked off, something like that. These magnets are part of the system the creates the electrical power for re-charging the battery and running the bike. As long as the stator is not damaged and ...
...don`t what happened went to start it it was hard starting and sound like **** no idle no thottleup power theres really nothing to the carbs but it don`t run black smoke out the exhaust pluggs wet
no power to coil make sure your on/off switch is on.... - happens to us all. if it is, then get a test light and check for power to your on/off switch, make sure there is power to it when you turn the
Question about kawasaki GPZ 500 S - GPX 500 R Motorcycles
Getting no power to nothing. Battery good. starter relay Getting no power to nothing. Battery is fully charger. The main 30amp fuse on start relay is good Could it be the starter relay I don't think ...
...Check that on/off switch hasn't shorted out, when you hit the start button you should be sending power to your solenoid which sends power to the starter motor. If your stator/ rotor cover seal is ...
4 questions posted
Usually answered in minutes!
30 Questions
14 Questions
13 Questions
12 Questions
11 Questions