1990 kawasaki ZZR 1100 "jet airways" Questions

my carbbys keep cuttin not wanting to idle most likely problem will be the slow speed idle jets and airway's. you can try stripping and cleaning with a good quality carb cleaner and a compressor to ...

...airways and fittings in the carb. Remove the idle screw and the air screw on the outside throat of the carb and spray into the screw holes as well. < < READ CLOSELY > > Be sure to put ...

...the carb intake with no choke, if she runs for a few seconds then you know its fuel starvationclean jets & airways & blow through with compressed ...

...a quick job as they looked good enough. Full disassemble of carbs is needed. Thorough cleaning on jets and airways, vacuum and pilot screw adjustment must be done too.Check the spark plugs for lean ...

...airways and fittings in the carb. About 3/8" from the main jet you will see a small brass screw. This is the pilot jet adjuster. Turn the adjuster 1/2 turn counter clockwise. Make a scratch on the ...

valve and clean it so it moves freely too. And check that cold start valve's airway to the idle jet is not clogged. Use some carburator cleaning aerosol and compressed air

...it with tank liner. Then rebuild the carburetors top and bottom end of the carbs. I soaked the jets in carb cleaner and blew them out with compressed air. Got everything back together again.

...airways and fittings in the carb. Remove the idle screw and the air screw on the outside throat of the carb and spray into the screw holes as well. < < READ CLOSELY > > Be sure to put ...

...left in the carbs for 5 - 6 months or more then it will have left resinous deposits in the carb jets,airways & float pivots Strip & clean carbs paying particular attention to the jets - ...