rear disk brake dragging on 2001 xr250 is there an adjustment screw? the rod that comes from the foot brake lever has a spring and two nuts on it, use a backup wrench and loosen it, also the clamp for
Question about Honda Xr 250 Motorcycles
...lever back up when you remove your foot. It might be missing or broken. You might also have a mal adjusted switch that activates the brake light. it should be located near the pivot bolt for the ...
how to adjust the rear breaks rear brake cannot be adjusted only cleaned lubed and bled...lever can be adjusted using the pushrod at the master cylinder
...2001 Honda Recon? Loosen the rear-axle nut Rotate the chain-tensioners [on each side of the rear-axle bolt] to their minimum points. Remove the wing-nut of the rear-brake adjuster rod. Place the bike ...
rear caliper adjustment for new brake pads There is no adjustment of calipers - they are hydraulic. If you mean how do you push back the brake piston to allow you to install new brake pads, why didn't
Question about Honda Xr 250 Motorcycles
rear brake lever is sticking making my brek lights stay on It might be just an adjustment for the switch that is connected to the foot brake. There is also a spring that should be pulling up on the ...
...Brakes themselves work but the lights don't always come on You have two brake light switches. Neither one have an "adjustment" on them per se. I would suspect the pressure switch underneath the bike. ...
...should close and show very low ohms continuity. If you cannot get continuity...normally there is an adjustment to move3 the switch out further so the spring from the pedal pulls on the switch plunger ...
12 questions posted
Usually answered in minutes!