...upper and lower brackets and twist your front end into the straight position and recheck it eyeball it, if you cant get it to look straight and the forks look bent take to a mechanic and have him ...
...upper clamp , then snug up the steering stem nut just enough that it is starting to bind, then back it off enough that the bar turns smoothly lock to lock (probably1/4 to 1/2 turn). Then tighten the ...
...upper and lower right side , might need pliers for larger lower hose, remove entire air box revove injectors bank by unscrew mount screws and take off whole frame at once put a towel under and spray ...
Question about Honda VTX 1300 R Motorcycles
upper end gasket replacement leave it to the pros or average joe job? I got some seapage from rear jug top end middle and lower rocker arm cover. I looked at the service manual and it looks like a fun
...replace the upper rocker box gaskets is not too difficult. But, if you're replacing the gaskets between the head and the lower plate, this gets a bit more involved. You must remove the fuel tank as ...
...upper bolt - - this will cause the battery tray to swing down when they are removed. Orient the new battery same as the old one... reverse the process..... thats it Hi, Elderdc sorry you can not find ...
Question about Honda VTX 1300 R Motorcycles
...lower the front of the bike by loosening the triple tree clamps and allowing the upper tubes of the front forks to slide upwards about an inch, no more that that though. These are simply suggestions ...
...upper case half. You will not need to tear down the top end at all unless you choose to replace the rings. An observation; you are a brave man, a very good mechanic, or someone seeking adventure if ...
Question about Honda VTX 1300 R Motorcycles
upper and lower brake hose crimps and securing both the wheel speed sensor cable and the brake hose along with the front fender tip lamp wires, if is has a fender tip lamp. THEN about 2.5 in. (63.5 mm
Question about Honda VTX 1300 R Motorcycles
...replace it ? Your Heritage has two fuel tanks. Each half bolting to the frame. First remove the small screw that holds the trip reset knob on if your bike is equipped with one. Then remove the dash ...
217 questions posted
Usually answered in minutes!
188 Questions
186 Questions
195 Questions
151 Questions
131 Questions