...remove the brake pads, since you have some mechanical idea ..by looking to the rear caliper you will figure out as to how to go about it. Once you have removed the pads just check the caliper pistons ...
Question about Yamaha Motorcycles
...rear brake pads. Did you remove the parking brake linkage? Actuate the parking brake lever. Do you see the parking brake linkage move? Depending on what you find. You may have to adjust the threaded ...
Question about Yamaha Motorcycles
remove rear brake caliper on that there will be a bar to stop caliper from turning when braking remove, remove axle nut, axle should push through swinging arm and wheel some times they will rust in if
Question about Honda CBR 125 R Motorcycles
rear brake binding on 2003 yzfr-6 after rer tire rear brake binding on 2003 yzfr-6 after rear tire replace caliper was binding I removed it cleaned the slides bottomed the piston out and it worked ...
...rear brake resover cap ,drain some fluid out,remove brake pads,clean piston,push piston back into caliper,refit pads,pump up rear brake as above and maybe split it and temove pistons and clean out ...
Question about Honda CBR 125 R Motorcycles
Rear brake caliper is rattling, can it be tightened?? Calipers normally do not get lose enough to rattle.Take a look at the pads..they have metal plates behind them that clip to the caliper sometimes ...
remove rear wheel from yamaha 650 v star The final drive has a spline shaft. Raise the rear wheel off the ground , loosen the rear axle nut, take out the axle bolt, knock out the spacer , unbolt the ...
Question about Honda CBR 125 R Motorcycles
...remove them. The rear caliper is now exposed - the real fun begins. Two bolts hold the caliper to the caliper arm - remove them and lay the caliper on the arm. Remove the black plastic dust cover on ...
...rear brake caliper, I have removed the old seals, cleaned the oxidization from grooves, renewed the seals and bled the system. All appeared fine, on the test ride the caliperbegan to get very hot, ...
...remove them. The rear caliper is now exposed - the real fun begins. Two bolts hold the caliper to the caliper arm - remove them and lay the caliper on the arm. Remove the black plastic dust cover on ...
120 questions posted
Usually answered in minutes!
99 Questions
47 Questions