...VTX 1300R...The bike set for about 3 months and now when I try to ride it..it will only run on choke..if I try to take the choke off..it just dies...no matter how "warmed up" it is...does this sound ...
bike starts with choke pulled but stops running when choke is released on my 2007 vtx 1300 honda tap bowl on carb sounds like float stuck in down position,
...vtx 1300 c stalls out after down shifting. Have needed to keep choke slightly out to keep from stalling. What to do? Thanks. ever drain your carbs ? should be done seasonally . fuel filter problem, ...
Question about Honda CR 250 R Motorcycles
vtx 1300s honda - starts sluggish - when it warms up finally, it runs good . somtimes the choke runs good and every thing is fine. today started it up, ran to the first red light , the bike died, ran ...
Question about Honda CR 250 R Motorcycles
...vtx 1300s have to run with the choke out or it dies when i down shift or stop, cleaned the carbs still doing it Wish I could help but mine , '06 does the same thing. Turned the idle up and it helped ...
Question about Honda CR 250 R Motorcycles
...VTX 1300R 07. Let it run out of gas and now it won't start. When I spray starting fluid into the breather intake it will start and run until it burns of the starting fluid. I did put gas back in the ...
...VTX 1300R has new battery, starts fine,accel good but idles rough sometimes to the point of stalling Make sure the choke is pushed ALL the way in. If you've been using it, you may have fouled the ...
vtx want start 2006 I had it running and it died and went and try to start it up and want start Thanks for the want details: you do have gas in it? It is fresh gas? Does the engine crank? Did you turn
Question about Honda Motorcycles
...vtx 1300 will not run with choke all the way in but will run with the choke half way in. what is the problem? After my bike warns up I push the choke in and the bike stops. If I push the choke only ...
Question about Honda CR 250 R Motorcycles
choke is on just a little bit and miss-fires when riden. Have put new plugs in and stripped the carb and cleaned all jets and adjusted the pilot screw as per manual have you syncronized the carbs? Can
30 questions posted
Usually answered in minutes!