...fully engaging when you release the handle. This will cause the clutch to slip for a second or two until the cable fully releases from the bind. Any resistance in the cable and you should replace
Question about Honda CB 250 Nighthawk Motorcycles
...replace it with an other make bearing Clutch Lever As the clutch lever is operated over time, it gradually loses its grip on the clutch cable, weakening the clutch lever action until it barely moves ...
Question about Honda CB 250 Nighthawk Motorcycles
...clutch cable itself has broken strands that is making in bind up. Disconnect the cable at the motor (transmission) now see how difficult it is to squeeze the clutch lever on the handle bar. If it is ...
Question about Harley Davidson Motorcycles
replace clutch plates, and Pressure Plate> or just pressure plate???? Make sure the ball and ramp was in the proper position after you replaced the clutch cable. It should have been to the rear
...replace the clutch on an off-road motorcycle or ATV. .... Hi I have a 05 drz400sm an I just did theclutch wire, tusk clutch ... I would start with the most obvious like properly adjusting your cable ...
...replaced If you replaced the cable and you have no clcutch, recheck your work. Typically, you must adjust the clutch and or the clutch cable for proper operation. Thanks for your interest in ...
19 questions posted
Usually answered in minutes!
24 Questions
16 Questions
18 Questions
12 Questions
14 Questions