idle speed with the idle screw. This should get you back on the road. i agree with tombones, but you should also check your needle valve setting to lean and your going to have a lean seize,to rich and
cr125 problems with acceleration hi i have a cr125 1997 and it starts first time doesnt idle but revs well. the problem is when i put it in gear it wont accelerate it jus goes at lowest speeds could u
Question about Honda CR 125 R Motorcycles
...idle screw and the air screw on the outside throat of the carb and spray into the screw holes as well. < < READ CLOSELY > > Be sure to put these two screws back in the same hole they came ...
Question about Honda CR 125 R Motorcycles
My bike seems to be runing way to ritch and tuning the carb dosent seem to do anything, we set the carb needle upp so it was as lean as it could go but still nothing? Also since its to ritch it wont ...
Question about Motorcycles
...adjust the idle mixture screws first and then adjust the idle speed screw to compensate adjusting the idle mixture screws will alter the idle speed but when properly adjusted then adjust the idle ...
...motorcycle's ideal operating temperature. 3 Take note of the engine idle speed, using the tachometer needle, while the engine is running. Ideally, the engine should idle steadily at 1,250 rpm. 4 ...
...adjust idle?? If your bike is equipped with a carburetor, the idle speed screw (throttle stop screw) is located on teh top right of the carb. You may have to remove the air filter cover to see it. ...
Question about Aprilia Motorcycles
...motorcycle's ideal operating temperature. 3 Take note of the engine idle speed, using the tachometer needle, while the engine is running. Ideally, the engine should idle steadily at 1,250 rpm. 4 ...
low idle How do I adjust the idle? mixture is non adjustable but idle speed is. located under the carb near the breather cover on the right hand side is a knob that will turn to set idle speed
...speed to high on my 2002 springer how to adjust idle speed Did you just mess with the carb? Could be an intake leak. Adjust throttle cables for correct freeplay. Then turn down idle via idle
224 questions posted
Usually answered in minutes!
62 Questions
35 Questions
38 Questions
2 Questions
1 Questions