Question about Honda VT 1100 C3 Shadow Aero Motorcycles
...the resivor and add brake fluid...repeat the process until all the air is out.....important point is to insure the hand brake lever is in motion when you open and close the air
Question about Honda VT 1100 C3 Shadow Aero Motorcycles
...brake hand control. If the lever is too low, check the level of the fluid in the master cylinder. Add on the correct type of fluid as listed on the master cylinder top. Do not mix different types of ...
Question about Honda VT 1100 C3 Shadow Aero Motorcycles
...Add brake fluid and then put the cap back on the cylinder. Now bleed air out of the brake system > pump the lever 3 times & then hold the lever in. Now loosen the bleeder bolt on the wheel ...
...add break fluid to rear breaks the rear brake reservoir is at the front r/h side of the bike on the frame rail just above the rear brake lever,you need to remove screw that holds it to remove metal ...
Question about Honda VT 1100 C3 Shadow Aero Motorcycles
tight pump the brake lever and it should tighten. Then check your brake fluid level and add fluid in needed. If this does not work, there may be other problems with the calipers and or master cylinder
Question about Honda VT 1100 C3 Shadow Aero Motorcycles
...brake fluid reservior is nearly level, usually all the way to the left. Remove the two screws and take the top off the reservior. If you add any fluid, make sure you put the correct fluid in the ...
Question about Honda VT 1100 C3 Shadow Aero Motorcycles
...brake reservoir and check fluid level. Add fluid to proper level and slowly squeeze the lever, watching for bubbles or fluid flow in the reservoir. Check the brake calipers to ensure there is not a ...
Question about Honda VT 1100 C3 Shadow Aero Motorcycles
cylinder for fluid. Then check down the brake line to the caliper looking for leaks. Lastly check the caliper for leaks. If the resevoir is low/ empty and you add fluid dont forget to bleed the system
...brake master cylinder and check the fluid level. If you add fluid during this process, make sure you are putting the right kind of fluid in the reservoir. It should be printed right on the top cover ...
Question about Honda VT 1100 C3 Shadow Aero Motorcycles
...add fluid, it must be tbe correct type. The correct type is written on the reservoir top. Now, depress the brake pedal or the brake lever and hold it. Open tbe bleeder valve, allow the pressure to ...
39 questions posted
Usually answered in minutes!
71 Questions
53 Questions
19 Questions
7 Questions