1998 Honda VTR 1000 F Firestorm "replace rear break lines" Questions

rear breaks- K100 There is a leak somewhere in the brake line...you are going to have to do a hand-over-hand trace of the brake line from the pedal (master cylinder) back to the caliper, find the leak

...comes out of the master cylinder and heads back towards the rear wheel. Somewhere in the line there is a "tee fitting" with the pressure switch screwed into it. Replace this switch. Good Luck ...

...rear. Bled system but front remains poor, and no back break at all.This is on a aprilia atlantic 125cc with assisted breaking find the bolt that attatches the brake line to the master cylinder. crack ...

...replace a shock mount bolt - before the repair my front hand brake would trigger brake light but not the foot pedal - after disassembling for shock mount repair I am left with tail light but no brake ...

rear pads, it is likely that they are the originals and 30 years old!! If in doubt of their age, replace them with current pads. They aren't expensive and this could well save your life. Similarly

rear works fine. Hummm......first, check the fluid level in the master-cylender. If one or both fluid chambers is empty, you will have to bleed the brake system. If the master-cylender is full, get in

rear caliper were scarred/market, had to replace them. The master cylinder up on the right side, just below the seat had black/black brake fluids, needed a complete flush. With a 1/2 gallon of Wlamart

...replace the switch. Once you get the rear brake light switch working, if the front brake light switch does not work, it must be replaced. To replace that switch, remove the two bolts that hold the ...

...rear brake switch, no luck. XL1200L sportster. Is there a circuit breaker??? Where ? Change the light bulb It should have two filaments inside and one of them is broken there is a break pressure ...

...break pipes from Goodridge and the front section (master cylinder to y split) in the kit for the XS1100 is too short and not at the correct angles try here it may help ...