mixture screw Does any one know the stock setting of the fuel mixture screw of a 1997 Honda xr250r? 1 1/4 to 1 1/2 turns out. Dont screw it in too tight or you'll bend the end of the needle.
Question about Honda XR 250 R Motorcycles
mixture screw 2,5 rotations ( 900 degrees) out from fully screwed in. This should return your bike's mixture settings to approximately standart. Then, using this page http://www.dansmc.com/spark_plugs
...accelaration 1983 XL250 new carb idles great but misses when you get on it. No popping sound.mixture screw out 2 1/4 turns. Air filter is clean, clean fuel also. Probably only needs a new Spark
...position mixture screw setting There is only a manual for an XR250 but it may have the information you need. Go to http://www.carlsalter.com/motorcycle-manuals.asp , and download a (free)
Question about Honda XR 250 R Motorcycles
...mixture screw? It's a '91 model. When is the last time you had the carb cleaned out? Sounds like you've got a stopped up low speed jet. The hole in that jet is less than 0.020" in diameter. Doesn't ...
mixture screw right on the carb will be a screw and idle screw you need to turn this in 1/4 of a turn at a time with the bike running until it idle ok and the mixture screw you simply just fiddle with
Question about Honda XR 250 R Motorcycles
...out mixture screw opening with spray carb cleaner. Will it run if you have someone spray carb cleaner in the intake when you turn it over? This will verify a clogged carb. make sure you use fresh
Question about Honda XR 250 R Motorcycles
...Mixture screw should be at about 2 turns out. Im guessing right now it will only idle with the choke on, or run with the choke partially on. When you let off the throttle off, deceleration it back ...
...screw and mixture screw the screw that is th smallest and the furthest in is the mixture screw you will reccomend a manual to adjust the mixture in the manual it will say e.g.mixture screw: 1 1/2 ...
...mixture screw. jot that info down. Then remove the mixture screw and spring. spray carb cleaner in the hole for the mixture screw, using the straw that comes with the can. this will ensure you have a ...
35 questions posted
Usually answered in minutes!
85 Questions
22 Questions
21 Questions
20 Questions
21 Questions