...Idle screw all the way up. Had to spray either to start it but it starts on its own, but sometimes not. Got it to run with hand aways on throttle. Then then H ppipe got cherry red! What do i do? Your ...
...idle screw and the air screw on the outside throat of the carb and spray into the screw holes as well. < < READ CLOSELY > > Be sure to put these two screws back in the same hole they came out of. ...
Question about Motorcycles
the idle mixture screws first and then adjust the idle speed screw to compensate adjusting the idle mixture screws will alter the idle speed but when properly adjusted then adjust the idle speed screw
Question about Honda CB 250 Nighthawk Motorcycles
...Idle Screw (Air/Fuel Mix): The idle screw, also known as the pilot screw, adjusts the air/fuel mixture at idle. It affects the fuel flow from the pilot jets (idle jets) into the carburetors. Locate ...
...IDLE SCREW adjusts the idle SPEED. Try screwing in the AIR SCREW 1/2 a turn and see if that helps. If not, try another 1/2 turn. Still no idle? Turn the screw back where it was (1 full turn) and then ...
Question about Honda CB 250 Nighthawk Motorcycles
idle, screw the idle mixture in until it just barely "bottoms" in the hole. Back it out 1 1/2 turns on the "butterfly" carb and about 3 turns on the "CV" carb and start the engine. Adjust the screw to
Question about Honda CB 250 Nighthawk Motorcycles
...vacuum leaks and the idle screw is turn up. Then adjust the a/f ratio screw to highest idle, turn down the idle screw and repeat until a/f screw makes no change. At that point you set your idle
25 questions posted
Usually answered in minutes!
24 Questions
18 Questions
12 Questions
12 Questions
14 Questions