1991 Honda CBR 600 F(2)M "coils checking" Questions

how to check for spark, harley springer Ignition Coil Primary Circuit Test Remove the coil. THEN set your ohmmeter scale to RX1 and place ohmmeter leads on the primary coil windings A (front of coil) ...

...R thunder cat: only running on 2 cylinders... Only running on 2 cylinders probably a bad coil, the coils are set up #1 and #4 from one coil, and #2and #3 from the other. check to see if your get 12v ...

I have an 05 softail duece with manual choke, engine will turn over fine but I have no fire at the plugs, installed new plugs, still no fire Ignition Coil Primary Circuit Test Remove the coil. THEN ...

throttle cable install What year???? For some models and years, but do not know if it fits yours as I do not know what year you have: Ignition Coil Primary Circuit Test Remove the coil. THEN set your ...

BIKE RAN GOOD BUT HAD BACK FIRE ONCE IN A WHILE REPLACED COIL RAN GOOD FOR 100 MILES SHUT IT OFF NOW HAVE NO SPARK TO PLUGS Could be an ignition module. Check the coil first. Check your pick-up sensor

1998 FLHT wont fire up engine turns over but wont't start up Are there any codes. Does it backfire? To start you need spark at the plugs, fuel in the induction module or tubes and compression in the ...

How do I check the ignition coil The bike will not start I checked for spark and there was none Ignition Coil Primary Circuit Test Remove the coil. THEN set your ohmmeter scale to RX1 and place ...

coil not firing Not firing through plugs Either your coils are bad, or they are not getting power, or they are not getting a signal from the pulse coils. Check ignition fuses Check for ~12V at coils ...

My1991 cbr 600 is only running on number 3and4 cylinders have you checked your coil pack and make sure you have correct spark to both cylinders

bike has no spark Check your pick-up sensor located inside the timing cover, behind the adjustor plate. If the filament is not intact you will have no spark. A defective coil, cam position sensor, or ...