Question about Harley Davidson FLHR Road king Motorcycles
...pressure off front tire...take off the axle nut lbit more to take pressure off axleock washer and flat washer...Next remove two axle support nuts from the right side of bike 1/2 in socket. now jack ...
...pressure off tire forth on right side of bike take the two half inch nuts off the axel support plate fifth hammer, push, use a punch what ever to press the axle out. then jack bike up to clear tire. ...
tire pressure too low. Often 35 PSI will keep the tire wear more even. If you ride a long distance with a strong cross wind you may notice wear on the windward side of the tire (just off center). This
Question about Harley Davidson FLHR Road king Motorcycles
...pressure on the shock absorber bolts and remove the lower ones and then lift the motorcycle higher to increase clearance between the tire and the fender.THEN unplug license plate lamp connector and ...
Question about Harley Davidson FLHR Road king Motorcycles
...pressure on the shock absorber bolts and remove the lower ones and then lift the motorcycle higher to increase clearance between the tire and the fender.THEN unplug license plate lamp connector and ...
...tire seated properly on the wheel? There's more to a front suspension system than merely changing the bearings out. Unless you've been using a pressure washer on the bike, odds are nothing is ...
Question about Harley Davidson FLHR Road king Motorcycles
tire was still going it did not try to slow down. the arm on top of the case where clutch cable goes after you pull the clutch in you have to reach down by hand and move the arm back out, i checked to
...tire so that it will be able to make through the forks once its loose. standing in front of bike facing it. on your left side of wheel is a bolt at the axel that should be a large allen/hex head bolt ...
tire is just touching the supporting surface apply two or three drops of LOCTITE MEDIUM STRENGTH THREADLOCKER 243 (blue) to the threads of each mounting bolt then install the lower shock mounting bolt
...tire noise. I rode a 3 day 1,100 mile trip and didint here this noise ,until I let it sit for a week and washed it. then it started. OK first things first, when washing your bike do not use high ...
97 questions posted
Usually answered in minutes!
180 Questions
151 Questions
21 Questions
15 Questions
11 Questions