2006 Harley Davidson FLHR Road king "start switch problems" Questions

switch, and all I hear is a single click. Then I turn it off, attempt to start again and the bike starts. Usually a single click indicates a bad "starter relay" http://www.jpcycles.com/product/380-589

...start or turn over new battery What does it do??? Any clicks etc??? Post more informationm to narrow it down. I had the same issue acted like a dead spot on starter. Dealer had for a week and could ...

...switch... set to run... you can hear fuel pump run...hit start button... nothing. Just buzzing from behind left side panel. starter relay... swapped out...nothing. same noise buzzing relay... won't ...

...start i right back up if it stalls out. It's normal for the check engine light to take from 0 to a couple seconds to turn off. The computer runs a system check. Put an oil pressure gauge on the bike ...

...Start by checking all electrical connectors and make sure they are plugged in good. Good Luck steve My 2000 FLHTCI is doing the same thing. I was told it could be a sensor (I think the speed sensor) ...

...start switch depressed mothing happens, not even starter click. Battery good, no fuses blown, all electrical works except start I'd guess either the "Run/Start" switch in in the "stop" position, ...

...the switch at the dash, you hear to pump primer noise. It appears that the switch is not working. I started the bike but had to shut it off at the dash instead on the run switch. I did pull apart the ...

switch housing, start the upper and lower switch housing screws but do not tighten them at this point, verify that the wire harness conduit runs in the depression at bottom of handlebar, put the brake

...switch in AC VOLTS, 50 VOLTS or greater. Start the engine and bring it to a high idle. Touch the meter leads to the two contacts down in the case. You should read at least 30 volts. So, if you don't ...