Question about Harley Davidson FXD - FXDI Dyna Super Glide Motorcycles
...engaging. plenty of brake fluid.just bought new brake pads, and still no breaking. Try bleeding the caliper. open the screw and squeeze the brake allowing fluid out and then closing the screw before ...
...pin (18Nm) and the plug (12Nm), push the brake pedal many times until it's fully engaging the brake.Then add some brake fluid to the tank until it reaches the "max" mark and close it.And you're
Question about Harley Davidson FXD - FXDI Dyna Super Glide Motorcycles
...calipers), no improvement. Brake handle comes almost to hand grip. Feels like when the brake handle is depressed, it goes more than 1/2 way before brakes engage. Both sets of front brake pads have ...
Question about Harley Davidson FXD - FXDI Dyna Super Glide Motorcycles
brake lever action/pull - they don't start engaging till bottom third of the pull. Is there a way to adjust the travel on the brake lever? Thanks! This is by design. When you have new pads on the bike
Question about Harley Davidson FXD - FXDI Dyna Super Glide Motorcycles
...will have to overhaul the brake calipers, it seems the pistons have jammed in there probabely due to rust on it at the pitted areas. Better still is to overhaul the brake mastercylinder too. Good ...
Question about Harley Davidson FXD - FXDI Dyna Super Glide Motorcycles
eychange brake pads on a 2012 wide glide harley Rear Brake Caliper For FLD Models remove the right saddlebag. For ABS equipped Models remove the cable strap securing the wheel speed sensor cable to ...
Question about Yamaha Motorcycles
the parking brake fails to work on a Yamaha majesty yp400 after a brake pad install. Sorry but I need more details. I can not see what you see. Please write back and tell me what you did (Step by step
Question about Harley Davidson FXD - FXDI Dyna Super Glide Motorcycles
new master cylinder and brake line on 2002 wide glide no brake preasure wheel turnes no brake preasure what next First thing, is the bleeder valve on the caliper at the wheel in the high position? If ...
Question about Harley Davidson FXD - FXDI Dyna Super Glide Motorcycles
...calipers need to be cleaned out. Remove the caliper and push the pistons out either with brake pressure from the master cylinder, or use air pressure from a compressor. If you use a compressor use a ...
Question about Harley Davidson FXD - FXDI Dyna Super Glide Motorcycles
Back brak stays down if you mean that the back brake stays engaged on the disc and gets hot. you probably have either a bad caliper or bad flex hose that leads to it. if it is just the tail light your
103 questions posted
Usually answered in minutes!
681 Questions
595 Questions
586 Questions
644 Questions
456 Questions