Question about Harley Davidson XL 883C Sportster Custom Motorcycles
...lift the seat off the2001 125nsr you put the starter key in the seat lock /under the back left side of the seat / turn the key and pull down the lever / then you can pull the seat back to remove it
Question about Harley Davidson XL 883C Sportster Custom Motorcycles
...presto seat and bike have now parted company. Good luck putting it back on it's harder to get all the slidy bits to re-engage (particularly the two in the middle that have to slide onto two
...put 13' apes on my 2001 ultra classic. so i had to extend my wires i took the pins out of the plug and i think i got some backwards my radio is turning it self up and down and getting some feed back ...
Question about Harley Davidson XL 883C Sportster Custom Motorcycles
...back on the swing arm lowering bike about an inch .a better way is to seek out shorter shocks,measure distance from mounting bolt centers & look for shocks that are an inch or so shorter;or AIR ...
Question about Harley Davidson XL 883C Sportster Custom Motorcycles
...put back in the carb without pinching it or having it come out of its groove when you put the cover back on. Easy way to be sure that you have it in place when the cover is back on is to blow ...
Question about Harley Davidson XL 883C Sportster Custom Motorcycles
...put the case back on yet. a simple test to see if it has worked is to gently hold the float whilst blowing down the fuel line. As you move the float up and down by hand it should be harder or easier ...
back of the seat that you need to take out to get the seat off. Remove the bolt, lift up on the rear of the seat and pull to the rear. seat is off. Now, down by the battery, there is a strap that runs
...put these two screws back in the same hole they came out of. IMPORTANT > do not tighten these two adjusters down. Only screw these in until they LIGHTLY seat. Now turn each adjuster one and one ...
Question about Harley Davidson XL 883C Sportster Custom Motorcycles
...put it back on, it will not read or will break off the little wings that seat in the wheel. the piece i am talking about normally falls out when you take the wheel off. the housing for it is what I ...
Question about Harley Davidson XL 883C Sportster Custom Motorcycles
...put these two screws back in the same hole they came out of. IMPORTANT > do not tighten these two screws down. Only screw these in until they LIGHTLY seat. Now turn each screw one and one half turns ...
54 questions posted
Usually answered in minutes!
37 Questions
14 Questions