2004 Harley Davidson XL 883 Sportster "pinch bolts" Questions

...pinch block bolts on each side, loosening the jam nuts on both adjustment screws, checking the axle alignment before adjusting belt tension, verifying that the axle housing is tight against the head ...

...it up out of way.then remove front fender.loosen axle nut and remove and remove wheel then loosen pinch bolt on the thriple trees hang on to fork tubes they may slide ...

...bolts = 12-15 ft. lbs. Front Fork Upper bracket pinch bolts = 30-35 ft. lbs. Lower bracket pinch bolts = 30-35 ft. lbs. Fork stem pinch bolt = 30-35 ft. lbs. Front fender fasteners = 9-13 ft.

...pinch bolts as well as fluid/air gap level or fork capacity for a '00 v92sc You need 525cc's per tube, step up to a 15w as well. The factory says 10w. It doesnt provide enough damping. what do you ...

...pinch bolts = 8NM Brake caliper to fork bolts = 30NM Rear wheel bolts M10x53x1,25 = 60NM Brake caliper to fork torque needed if changing to SM wheels. Method. Torque greased axle bolt to 50NM, then ...

pinch bolts tight in that end of the axle. So, in order- 1-remove axle nut. 2-remove 2 bolts holding the brake caliper to the fork and tie it back out of the way.3 loosen the pinch bolts at the bottom

Help where are the pinch bolt located on the hurricane x75? a pinch bolt will fasten more the front suspension too the lower yoke they are as they say a pinch type fastening that tighten their grip on

...pinch bolts on each fork leg. If you don't have the big Allen key, do this- Remove the axle nut on the brake side. Remove the 2 bolts that hold the brake caliper on and swing it out of the ...

...pinch bolts to secure the axle for tightening the nut. tighten the nut to 29.5 ftlbs. and loosen the left pinch bolts. now tighten the right pinch bolts and compress the front suspension while the ...

...lever Kawasaki KX 125 motorcross-cant get the lever to come off, just hangs loose Does it have a pinch bolt? If so undo and remove the pinch bolt, if the lever doesn't slide off you will need to ...