...remove the outer primary case.The clutch,primary chain,adjuster, and compensating sprocket must be reoved as a single unit.Once you have done this take a rag and grasp the rotor and slide it off of ...
...outer primary on as well. I think they are the one at 12 o'clock and 3 o'clock position. There is also a small gasket between the inner and outer primary covers on these two bolts. Good Luck ...
Question about Harley Davidson FXD Dyna Super Glide Motorcycles
remove the outer primary cover to gain access to the bolt holding the clamp. Replace the O-rings with new ones. If possible, try to find one that is the same size but made of slightly thicker stuff so
Question about Harley Davidson FXD Dyna Super Glide Motorcycles
...Remove the outer primary cover. The stator is behind the compensating sprocket in the front of the inner primary. Increase the slack in the clutch cable at the adjuster. Lock the primary drive with ...
...remove the outer cover. Remove the small bolt that holds the starter jackshaft in and pull the jackshaft out of the seal. If the coupling comes out with it, make sure you mark the coupling which way ...
Question about Harley Davidson FXD Dyna Super Glide Motorcycles
outer primary or on the rear end of the primary. Take the plug out, fill until oil just starts to run out and stop. On the Big Twins, remove the derby cover, stand the bike straight up, and fill until
Question about Harley Davidson FXD Dyna Super Glide Motorcycles
...outer primary cover off. Remove the inner primary cover. Remove the small bolt that holds the starter jackshaft on and remove the jackshaft. Then go to the right side of the bike. Remove the exhaust ...
141 questions posted
Usually answered in minutes!
126 Questions
109 Questions
61 Questions
45 Questions
21 Questions