2003 Harley Davidson FXD Dyna Super Glide "mainshaft seal installation" Questions

...mainshaft (this nut has right hand threads).Remove the primary drive as an assembly.Remove the rotor. It is held on magnetically. Unplug the voltage regulator from the stator. Remove the 4 bolts ...

...seal as well as the mainshaft before you reinstall the inner primary. If you install the seal dry, when you start the engine the mainshaft will burn up the seal in about three seconds before the oil ...

...seal between the mainshaft and the final drive gear. I also replace the Quad Seal behind the spacer behind the belt pulley. This will require the special tools necessary to remove the pulley. If you ...

...direction, 68-80 ft. lbs. LEFT-HANDED on the clutch nut, a primary locking bar, a final drive sprocket locking device, a mainshaft nut removal tool, and some seal pullers and installers. Good

mainshaft. There is a starter seal up just a bit higher that can leak as well. You should have already checked the inner bearing race position on the mainshaft, 0.100" from the face of the final drive

...mainshaft and pulled off. If the race slides on, somethiing is wrong. If you take the seal alone, without the seal in the inner primary, and slide it on the race, there should be a tension, about ...

seal" behind the spacer on the transmission main shaft fails. Transmission lubricant seeps down between the mainshaft and the spacer and out of the splined area of the front belt pulley. Take the lock

...the dogs are not engaging. When I took it apart everything looked OK the only worn part was the mainshaft third gear shift fork could it be that? The worn shift fork is the problem. Normally a ...

...seal in between the two bushings so it doesn't leak. Put the new cover with the rest of the kicker parts in it back on the transmission and refill the transmission with lube. 20-24 ounces. If the ...