2003 Harley Davidson FLHTCUI Electra Glide Ultra Classic "idle voltage" Questions

My 2002 electra glide classic head light flickers when the bike is running? The voltage regulator is starting to fail. The headlight is flickering with the pulsing of the alternator when the motor is ...

...voltage. Start the engine and bring it to a high idle. Stick one meter lead (either one) into on contact in the engine side of the plug and the other lead into the other contact. Do not allow the ...

...idle or below 2000 RPM, no problems. Please help. Dont do that, your voltage regulator is faulty. It is in the alternator. Max charging voltage should be 14.2 and min 13.6v. Chk battery water level. ...

...idle. After about a minute or so, your meter should read between 14.5 and 15.0 volts. Any lower than 14 volts, your battery will not be charged. If you don't have the minimum voltage at the ...

...voltage meter goes up and down then when I sit idle it stays about 14 volts but if I sit idle and give it gas (rev the engine) it will drop to about10 volts.. It keeps going up and down. There is a ...

2001 hd ultra classic after running for a while and idling at a light volt meter pegs at 16 volts and other gages go erratic, unit shuts down i turn it off 20 sec. starts up and goes please help ...

...idle meter should read 12.80 +/- .25 volts - anything lower-voltage regulator bad Rev to 2000 rpm meter should read 13.75 - 14.80 volts - anything lower-voltage regulator bad Before replacing the ...

...idle revs. If it is higher than this, you will need a new regulator. if the voltage is in AC you need a new rectifier and battery. The reason the lights dim is due to insufficient current being ...

voltage drops idle brand new battery installed , after driving 35 miles notice volt meter drop to 8 , shut bike off would not restart ,would voltage regulater be bad This depends a lot on yeqr of bike

...voltage range. Now, start the bike and bring it to high idle. Insert the meter leads, one into each connector. Make sure you do not touch the engine cases. You should read 30 volts or greater. If so, ...