2003 Harley Davidson FLHTC Electra Glide Classic "throttle remove" Questions

...run again to see if it throws the error code on the same cylinder, or the opposite one. P0122 = TP (throttle position) Sensor Open/Low EFI Check that it's connected correctly, check electrical pins ...

remove the throttle cable from the carb/throttle body. Then take the two bolts out of the throttle grip housing halves and carefully seperate them. Remove the old cables from the twist grip. Reinstall

...remove the throttle cover on the grip. you will be able to see how they are removed. Then reverse these steps to install the new cable. To change cables 2 and 4 in no more difficult but more time ...

...throttle sleave. to remove from housing move in a circuler motion while pulling them from housing they will pull out as long as you pull them straight. then remove air cleaner cover and backing plate ...

...remove the throttle or right side grip remove the upper and lower switch housing screws, loosen the upper screw securing the handlebar clamp to the master cylinder housing. Remove the lower clamp ...

Throttle grip locked. My throttle grip will not turn. Not sure if something with throttle cable or what. This could be the slider inside the carb,The cable,or The throttle itself. start by removing ...

...remove throttle cable on 2002 dyna super glide 2002 make how do I remove throttle cable REMOVAL Loosen the cable adjuster jam nuts, screw the throttle cable adjuster until it is as short as possible, ...

...remove the spark plugs. If you have a compression gauge, connect it to one of the heads and spin the engine over with the starter. If you don't have a gauge, simply put your finger over the spark ...

...remove hoses & tank loosen throttle cable adjustment at the grip & at the carb then twist throttle cam wher its fitted & slide cable out of its clip then undo the twist grip & remove ...

...throttle sleeve and remove the barrel from the end of the cable of both cables. Now, the switch housing halves are free of the throttle sleeve. Work the cable you intend to change out of the switch ...