2003 Harley Davidson XL 1200 C Sportster Custom "regulator removal" Questions

BACKFIREING IN CARB This is a common problem due to the carburetor being jetted so lean. The carburetor is jetted very lean so that it will meet the EPA emission regulations. If you go up one size on ...

poping in crub I think you're talking about "popping in carb". This is because your carb is jetted too lean from the factory. They have to do this to meet EPA regulations. You need to change the slow ...

...check the stator and see if it is putting out any voltage, to do this you disconnect it from the regulator on the right front down tube at the bottom. Use a multimeter to read the voltage, I

...dead short somewhere on the bike. It is a 2001 1200 Sportster. I have replaced the voltage regulator and the ignition switch. I have searched the wire connections around the fuse box, and

...above. Am I looking for a short or something to do with a modulator or some other voltage/amp regulator. New battery was placed in the bike 1 week before problem and bike has only been started ...

How do I remove the voltage regulator from an Aprilia Atlantic 500? The cable seems to route from the regulator towards the front of the scooter. How much "stuff" do I need to remove to find

HOW TO CHANGE REGULATOR ON SYM 300 To change the regulator on a SYM 300, you will need to follow these steps: Turn off the engine and remove the key from the ignition. Locate the regulator, which is ...

...REGULATOR Removal/Installation Disconnect the negative battery cable Remove the rear fender inner panel raising the back wheel off the ground, remove the 2 bolts securing it at the bottom, push it up ...

Suzuki Marauder VZ800. Changing regulator on it please. I searched all over the web and can't find anything on this -- Does anyone know if the engine has to be removed to change the regulator? The ...

The regulator on my Ariel square 4 1958 appears to have a problem as it does not cut-out. The battery is new & fully charged, The amp meter registers from zero to 20 amps depending on engine speed. I ...