mm) from switch body. The new switch must be spliced into existing wiring harness using splice connectors. 5. After splicing new switch into wire harness, place switch into position. The word "TOP" is
Question about Harley Davidson FXDL Dyna Low Rider Motorcycles
mm) from switch body. The new switch must be spliced into existing wiring harness using splice connectors. 5. After splicing new switch into wire harness, place switch into position. The word "TOP" is
Question about Harley Davidson FXDL Dyna Low Rider Motorcycles
...mm socket and a socket wrench. 5 Lay the seat's foam next to the seat pan. Mark the approximate location of the back rest bar's protruding neck at the front of the seat onto the foam with a ...
6 Replace the worn parts and reverse the steps above to reinstall. Consult your service manual for the proper torque when tightening the bolts on the pressure and friction plate. 7 Check and make sure
Question about Harley Davidson FXDL Dyna Low Rider Motorcycles
...mm wrench. Remove the cables. 5 Hold the carburetors over a large container. Unscrew the drain screws on the side of each carburetor's float bowl, positioned at the very bottom of the carburetor, ...
Question about Harley Davidson FXDL Dyna Low Rider Motorcycles
mm), replace the worn pin. THEN inspect the torque clip and replace it if it is worn or damaged, inspect the anti-rattle spring and replace it if it is worn or damaged. THEN install new brake pads and
Question about Harley Davidson FXDL Dyna Low Rider Motorcycles
...mm mounting bolt into the bottom hole on the fork leg, tighten the bottom mounting bolt to 28-38 ft-lbs (38.51.5 Nm), final tighten the top mounting bolt to 28-38 ft-lbs (38.51.5 Nm), final tighten ...
...MM FXDXT 11.5 341 6.10 154.9 FXDWG 12.0 356 7.28 184.9 FXDL 10.7 316 7.20 182.9 FXD 10.6 314 6.69 169.9 Changing fork oil is a simple mater for some models and requires fork disassembly for others. ...
Question about Harley Davidson FXDL Dyna Low Rider Motorcycles
...mm mounting bolt into the bottom hole on the fork leg, tighten the bottom mounting bolt to 28-38 ft-lbs (38.51.5 Nm), final tighten the top mounting bolt to 28-38 ft-lbs (38.51.5 Nm), final tighten ...
98 questions posted
Usually answered in minutes!
127 Questions
96 Questions
87 Questions
20 Questions
16 Questions