Question about Harley Davidson FXD Dyna Super Glide Motorcycles
how do get the battery cover off 2010 dyna super glide custom Phillips screw under bottom of cover on righht side.
Question about Harley Davidson FXD Dyna Super Glide Motorcycles
add charger leads, but how would you change the battery?) That 4 point star you refer to is a large phillips head srewdriver slot w/ hexhead so when you can't get a socket or open end wrench on it you
Question about Harley Davidson FXD Dyna Super Glide Motorcycles
...of the seat lines up with the bolt hole on the fender and then screw the seat into place with a phillips screw
Question about Harley Davidson FXD Dyna Super Glide Motorcycles
...holder for the choke that sits on the left hand side of the carburetors. It is held in place by 1 phillips head screw. I have the fiche here but can't find the part number or where abouts it is on ...
Question about Harley Davidson FXD Dyna Super Glide Motorcycles
...+) Positive (Red) and (--) Negative (Black) terminal cables. You can use a size 10 spanner, a No. 2 Phillips screw driver or a size 10 socket drive to unbolt them, start with the Black terminal cable ...
Question about Harley Davidson FXD Dyna Super Glide Motorcycles
...in towards the tank. Basically check where the throttle cables go onto the pully, there should be a phillips screw with the head pointing outwards and up. Turn that screw in or out (very small ...
Question about Harley Davidson FXD Dyna Super Glide Motorcycles
...side of the outer primary cover. It's located near the bottom front of the case and is usually a phillips head screw. Stand the bike up straight and remove this screw and the round access plug at ...
Question about Harley Davidson FXD Dyna Super Glide Motorcycles
How do I replace centering pin for shifter. The centering pin is either broken off or pushed back so the shifter would not return to center. I am not sure if the hole the pin goes into even goes all ...
Question about Harley Davidson FXD Dyna Super Glide Motorcycles
...is removed with a small flat head screwdriver ( it's held in by 3 little push in tabs ) There are 2 phillips head screws( remove them ) then once you have the headlight out, there is a 5/16 nut ...
127 questions posted
Usually answered in minutes!
137 Questions
109 Questions
61 Questions
45 Questions
21 Questions